Grizzly Riding Toy H0771 User Manual

FOLDING SIDES GARDEN  
WAGON  
MODEL H0771  
INSTRUCTION SHEET  
COPYRIGHT © MARCH, 2004 BY GRIZZLY INDUSTRIAL, INC.  
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE  
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.  
#6143 PRINTED IN CHINA  
 
ASSEMBLY INSTRUCTIONS  
REMOVAL & INVENTORY  
1. Remove your new wagon from the carton.  
2. Make sure all parts are present and in good  
condition.  
FRONT SUPPORT ASSEMBLY  
1. Insert the yoke into the front axle support  
by sliding the top hole of the yoke onto the  
pivot post on the front axle support. Place  
the 10mm flat washer on the pivot post and  
slide the cotter pin in the pre drilled hole and  
spread. Bolt the center front axle brace and  
yoke to the bottom of the front axle support  
with the M8-1.25 x 17 shoulder bolt, 6mm flat  
washer and lock nut. See Figure 1  
Figure 2. Rear and front axle assemblies  
4. Slide a wheel spacer bushing, part 22, on  
each axle.  
Front axle  
support  
5. Slide a wheel onto each axle with the valve  
stems to the outside and fasten using the  
M12-1.75 acorn nuts, 12mm flat washers  
and lock washers.  
Center front  
axle brace  
Yoke  
FOLDING SIDES  
1. Using the panel assembly pins, fasten the  
hinges of the side panels to the bed, with the  
side panel hinges on the outside.  
2. Fasten the hinges of the front panel to the  
end with the front axle assembly using the  
panel assembly pins.  
3. Fasten the hinges of the back panel to the  
end with the rear axle support using the  
panel assembly pins.  
Steering  
Connector  
Figure 1. Front axle assembly detail.  
2. Bolt the steering connector to the steering  
arms of the front axle support and the yoke  
using M8-1.25 x 15 shoulder bolts, 6mm flat  
washers and lock nuts.  
3. Mount the front axle assembly to the end  
of the bed with the corresponding bolt pat-  
tern using M8-1.25 x 20 carriage bolts, 8mm  
washers and lock nuts.  
PULL HANDLE  
1. Slide the plastic coupling on to the pull  
handle, making sure the holes are correctly  
aligned.  
2. Place the pull handle and plastic coupling  
into the yoke and insert the M8-1.25 x 80  
slotted screw. Fasten using an 8mm washer  
and lock nut.  
Note—The Folding Sides Garden Wagon comes  
equipped with a tractor connector. Slide  
the tractor connector over the handle of the  
wagon and connect to the tractor hitch.  
REAR SUPPORT ASSEMBLY & WHEELS  
1. Loosely assemble the rear axle support to the  
bed using M8-1.25 x 20 carriage bolts, 8mm  
washers and lock nuts.  
2. Slide the left and right rear axle braces onto  
the rear axles and bolt the opposite ends of  
the braces to the bed using M8-1.25 x 20 car-  
riage bolts, 8mm washers and lock nuts. See  
Figure 2  
If you need additional help with this procedure,  
call our service department at: (570) 546-9663.  
3. Tighten the rear axle support.  
 
H0771 Parts Breakdown and List  
4
2
1
25  
16  
3
2
19  
20  
21  
8
6
32  
15  
7
9
10  
27  
12  
30  
31  
21  
20  
28  
22  
14  
18  
11  
13  
24  
26  
23  
33  
DESCRIPTION  
5
REF  
15 PW04M  
PART#  
DESCRIPTION  
FLAT WASHER 10MM  
REF  
1
PART#  
16 PH0771016 PANEL ASSEMBLY PINS  
18 PW06M FLAT WASHER 12MM  
19 PH0771019 MALE LOCK HANDLE M8-1.25  
PH0771001  
PH0771002  
PH0771003  
PH0771004  
PH0771005  
PH0771006  
PH0771007  
PH0771008  
PH0771009  
PH0771010  
PH0771011  
PH0771012  
PH0771013  
PH0771014  
BED PANEL  
2
SIDE PANEL  
FRONT PANEL  
BACK PANEL  
3
20 PW01M  
21 PLN04M  
FLAT WASHER 8MM  
LOCK NUT M8-1.25  
4
5
WHEEL 13" X 5.00-6  
REAR AXLE SUPPORT  
22 PH0771022 WHEEL SPACER BUSHING  
6
23 PN26M  
24 PLW05M  
25 PCB01M  
ACORN NUT M12-1.75  
7
LEFT REAR AXLE BRACE  
RIGHT REAR AXLE BRACE  
FRONT AXLE SUPPORT  
CNTR FRONT AXLE BRACE  
YOKE  
LOCK WASHER 12MM  
8
CARRIAGE BOLT M8-1.25 x 20  
9
26 PH0771026 SLOT SCREW M8-1.25 x 80  
27 PH0771027 SHLDR BOLT M8-1.25 x 15  
28 PH0771028 SHLDR BOLT M8-1.25 x 17  
10  
11  
12  
13  
14  
STEERING CONNECTOR  
PLASTIC COUPLING  
PULL HANDLE  
30 PW03M  
31 PLN03M  
FLAT WASHER 6MM  
LOCK NUT M6-1.0  
32 PH0771032 COTTER PIN  
14-1 PH0771014-1 PAD (LOWER)  
14-2 PH0771014-2 PAD (UPPER)  
33 PH0771033 TRACTOR CONNECTOR  
 

Grindmaster Washer 87710 User Manual
Grizzly Grinder H3172 User Manual
Grizzly Planer G1033Z User Manual
Hamilton Beach Slow Cooker 33351 User Manual
Hans Grohe Plumbing Product 31020001 User Manual
HP Hewlett Packard Digital Camera M305 M307 User Manual
HP Hewlett Packard Network Card EA833AA User Manual
HP Hewlett Packard Personal Computer DC5750 User Manual
Hunter Fan Outdoor Ceiling Fan 21325 User Manual
iHome DVD VCR Combo ID84 User Manual